Introduction:
For AM-30 jigging machine, the maximum feeding size is 30mm, and it can discharge up and down at the same time. As kind of large size jigging machine which was widely used at present,it can work continuously, .
Jigger of this model is only used to process hematite at first,  and now it has been also applied to the beneficiation of  limonite, specularite, manganese ore, barite, fluorite, lapis lazuli, mercury ore, antimony, etc  with its great dressing efficiency.

Working Principle:
AM-30 jigger is rectangle side-moving jigger with two rows and four chambers. The motor drives the reduction gear to move by the transmission belt and there are eccentric adjustment device at the two ends of the output shaft of the reduction gear. The eccentric adjustment device drives the connecting rod to bring the driving pan to do alternative motion squeezing the liquid in the cell body to move. The moving water-flows impact the ore on the screen to make the ore in the shape of free-falling body in the liquid. The ore grains own different dropping speed in the liquid because of the different density, so the ore will separate naturally.Finally, the heavier ore will be discharged out of the cell body after the adjustment and the lighter ore floats the waste-discharging mouth to be discharged and the whole ore beneficiation process is finished.

Advantages:
1, Energy-saving, high efficiency and environment-friendly.
2, Wide range of feeding particle size from 8 to 30mm.
3, Top and bottom discharging together
4, Continuous working, stable performance, high wear-resisting & long service life.

Technical Parameter:
 

Fluorite jig separator, fluorite beneficiation equipment

There are many kinds of jiggers for different ores. Choosing a suitable jigger is necessary to improve teh jigging beneficiation efficiency. The equipment for fluorite beneficiation is floatation separation and gravity separation. The floatation separation is mainly for low-grade fluorite, and fine grain size embedded to gain high-grade fluorite powder. And floatation separation is the only way to get high-grade fluorite powder. The gravity separation machine is mainly jigger. As kind of gravity separation machine, it separates according to different densities of mineral and gangue to gain metallurgy fluoeite. Jigging gravity separation is the only way to get fluorite blocks.

Gongyi Forui Machinery Factory improves the AM30 jigger on foundation of resource of ore beneficiation to develop new-type fluorite jigger. This fluorite jigger is of large treatment capacity, high recovery rate, wide feeding range, good beneficiation efficiency. This jigger has gained great praises and has been welcome to many proveinces in China, and it is exported to Mongolia for fluorite blocks separation.